CLEAN BURN CB-2800 Operator's Manual download pdf (Page 23)

Operator's Manual: Models CB-1500 & CB-2500 (230 V / 50 Hz)

3-3

Installing the Blower Assembly

1. Refer to Figures 3B and 3C.

2. Remove the blower stabilizer brackets as shown in Figure 3B. (These braces, which are installed

at the factory, are designed to keep the blower in proper position during shipping. Note that

these braces are provided on CB-2500 blower assemblies ONLY; CB-1500 blower assemblies do

not require these special shipping braces.)

3. Position the blower over the opening in the back of the furnace cabinet by sliding the blower into

the mounting angle brackets. Note that the mounting brackets may be loosened for adjustment,

as needed. The blower should be centered over the opening.

4. Fasten the blower to the brackets with self-tapping screws (provided). Drive the screws into the

blower housing through the holes in the mounting angle brackets. There are four holes along each

side and across the top of the bracket to fasten the blower to the furnace cabinet.

5. Install the blower safety guards as shown.

WARNING: To avoid serious personal injury, be sure to install both pieces of the blower guard

around the blower prior to operating the furnace. NEVER operate the furnace without all safety

shields/guards in place!

ATTENTION: The air flow is changed when the guards are not in place which may result in damage

to the blower motor.

NOTE: For proper air flow through the furnace cabinet the blower must be positioned so that the

bulge on the blower faces down as illustrated in Figures 3A, 3B, and 3C.

Figure 3B - Installing the Blower Assembly

ATTACH BLOWER TO FURNACE

REMOVE SHIPPING BRACES

I88691−D

X 2

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 121 122

No comments

CLEAN BURN CB-2800 Operator's Manual Page 23